GGI REVIEW: GHK's gas blowback AK74U (in progress)

[Spooky]

Yep... No news from my retailer in poland...

I would like to stick the broken piece.

Here is a picture of it:



Could you confirm that it is zamac? Is it possible to stick it? I heard about Epoxy glue?

[madhellsing]

yeah man, that's aluminum when banged stressed fracture. They definitely sold you the wornout one. Can you see the little air bubbles all arrownd the fracture, that's when they use a cheap casting technic (with no vacum) and they deffinitly used it up cause else it would it never'd happened .I dont know about glueing it because that's the part that takes more damage and epoxy only is cured by eather waiting for a week or two to harden or by using a UV lamp like the ones at the dentist's office but you need to know how to mix it because if you mix too much it will turn into rubber and before that you have to drill some holes in the stress fracture area to make the glue anchore down.

I mean if you really want that gun to work each and every time I suggest that you get the steel parts, in other words investing on it is actually a good investment since the steel parts will last for ever ever ever , and dont need to get all the parts for it. Just get the hammer pack.$70

[lukvdh]

...
Just get the hammer pack.$70

Can someone tell me where this is available?

Thanks!

[madhellsing]

go to www.daytonagun.com and send him an e-mail with your request and he'll respond in like 2 days.

[wraithxt1]

Well I have had my new GHK ak105 for exactly one day and 6 mags into it and it dies on me. I posted a thread in the GHK forum about it.

It also looks like they come stock with a metal bolt at this point ,at least he 105 from redwolf I got did.

Anyone care to take a look at my thread and help me out?

[lukvdh]

Well I have had my new GHK ak105 for exactly one day and 6 mags into it and it dies on me. I posted a thread in the GHK forum about it.
...

Perhaps a stupid question, but: where is 'the GHK forum' ?

Thanks in advance.

[Akimbo]

Hello,
i hope this Thread is not to old to hijack
Had buyed a used GHK AKSU. Very used and only with one CO2 Mag. It is on its way and will arrive in a few days.
I please need suggestions from you people. Should i wait till i got a Gas mag cause
of the higher pressure from CO2 ? And should i improve/(protect with silicon tape and stuff) the heavily used parts
like madhellsing wrote ?
I will post a picture i got from my trading buddy. The repaired bolt should not be the greatest problem.
Hopping to get ratech stuff to replace maybe. Much more i need suggestions to the used parts around the screws
seen in the pic. It scares me when i will take the AK apart to see for the HoppUp